Level Control System Solenoid -N111-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Level Control System Solenoid -N111- is located on the air supply unit.

-- Remove the air supply unit, refer to AIR SUPPLY UNIT, REMOVING AND INSTALLING .

NOTE:

Make sure no dirt gets into the pressure air system.

Clean the area before removing connecting pieces for the air pipe lines or other components of the pressured air system.

Seal off any open air lines and connections in the pressure system immediately with plugs or cover them.

-- Disconnect the connector -3- from the Level Control System Solenoid -N111- -2-.

Fig 1: Identifying Level Control System Solenoid Assembly

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1-.

-- Remove the Level Control System Solenoid -N111- -5- with the O-rings -1 and 4-, the spring -3- and the anchor -2-.

Fig 2: Identifying Level Control System Solenoid, O-Rings, Spring And Anchor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The O-ring -1- may still be located inside the air supply unit housing.