Air Supply Unit With Bracket, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
The vehicle may be removed from the vehicle hoist only after the air springs have been filled again, refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .
Make sure the positioning pin on the air spring is installed correctly inside the body before filling the air suspension system. The air spring must be locked secure inside the wheel bearing housing at the same time, refer to Fig 1.
Air suspension system, filling, refer to SYSTEM, VENTING OR FILLING .
If the air supply unit was replaced, then the Level Control System Compressor Relay -J403- must also be replaced. Installed location, refer to appropriate SYSTEM WIRING DIAGRAMS information.