Battery, Charging With Battery Charger VAS 5095A: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Check the battery type setting on the Battery Type switch, refer to BATTERY CHARGER VAS 5095A DEVICE DESCRIPTION . The Battery Type switch must be set to 2.4 V/C (Volts/Cell).

-- Connect the red charge terminal (+) to the positive terminal of the Battery -A-.

NOTE: On vehicles with a Start/Stop function and an installed Battery Monitoring Control Module -J367-, the black charge terminal (-) must be connected to the body ground. The Start/Stop system will malfunction when it is connected to the Battery -A- negative terminal.

-- Connect the black charge terminal (-) to the negative terminal of the Battery -A- /negative connector.

-- Switch on the Battery Charger VAS 5095A, refer to BATTERY CHARGER VAS 5095A DEVICE DESCRIPTION .

Charge current displays Figure -2- and -3- light up yellow. The Battery -A- is partially charged (approximately 90%) when only the yellow LED -3- is on.

If the green LED Figure -4- is also on, then the Battery Charger VAS 5095A has switched to maintenance charging. The Battery -A- is charged.

-- Switch off the Battery Charger VAS 5095A, refer to BATTERY CHARGER VAS 5095A DEVICE DESCRIPTION .

-- Remove the charging clamps from the battery terminals.