Adaptive Cruise Control, Calibrating: Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

The distance regulation control module must be calibrated during the following conditions:
- The Distance Regulation Control Module - J428- / Distance Regulation Control Module 2 - J850- was be replaced.
- The Distance Regulation Control Module - J428- / Distance Regulation Control Module 2 - J850- was be removed and installed.
- The front bumper was damaged.
- The front bumper was loosened, adjusted, or removed and installed.
- The rear axle toe was adjusted.
- The adjustment angle is greater than -0.8° to +0.8°.
- Too large of a vertical adjustment for the distance regulation control module (leads to a blind spot deactivation). Functional limitations emerge due to limited sensor sight, which is not the result of a dirty sensor or inclement weather conditions (for example, heavy rain/snowfall, iced over sensor, etc.).
- The DTC "no or incorrect basic setting/adaptation" is stored in the DTC memory.