LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Seat Frames) >> 72 Seat Frames >> Rear Seats >> Seat Bench/Single Seat, Removing And Installing >> Seat Heating Control Module -J882-, REMOVING AND INSTALLING >> Installing

Seat Heating Control Module -J882-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Module, Bracket & Adhesive
GWWA72-11635Courtesy of AUDI OF AMERICA, LLC

-- Install the control module -1- into the bracket -2- and remove the protective backing from the adhesive pad -3-.

-- Install the control module with the mount into the wiring guide and press it forcefully to the body.

Installation is performed in reverse order of removal, while noting the following:

scientia non olet · About LEMON Manuals