Rear Bench Seat, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Latch Bracket Cover Caps

Courtesy of AUDI OF AMERICA, LLC

-- Move the front seats all the way forward.

-- Unclip the LATCH child seat anchor guides (quantity: four) -1- from anchorages -2-. Refer to REAR CHILD SEAT ANCHOR, REMOVING AND INSTALLING .

-- With both hands, grasp the rear seat bench under the seat frame.

Fig 2: Insert Bench Seat And Press Wire Frame "Firmly" Into Grommets

Courtesy of AUDI OF AMERICA, LLC

-- Pull the rear seat bench -1- up forcefully with both hands -A arrows- so the wire hooks -2- on the rear seat bench disengage from the mounting grommet -3-.

-- Repeat the procedure on the other side of the rear seat bench -B arrows-.

-- Versions with heated seats: Disconnect the seat heating electrical connector.

-- Remove rear seat bench from the vehicle.