LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Seat Frames) >> 72 Seat Frames >> Rear Seats >> Rear Seat Backrest, Removing And Installing >> Outer Bearing Sleeve, Removing And Installing >> Removing

Outer Bearing Sleeve, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Unclip Mount From Backrest
GWWA72-10646Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear seat backrest. Refer to Removing .

-- Unclip the bearing sleeve -2- from the rear seat backrest frame -1- using the Trim Removal Wedge 3409 and remove it.

CAUTION:

Be careful not to damage the backrest cover when removing the bearing sleeve.

scientia non olet · About LEMON Manuals