LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Seat Frames) >> 72 Seat Frames >> Rear Seats >> Rear Seat Backrest, Removing And Installing >> Inner Mounting Pin, Removing And Installing >> Removing

Inner Mounting Pin, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Inner Bearing Assembly Overview
GWWA72-10647Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear seat backrest. Refer to Removing .

-- Remove the chafe protection -4- and then remove the mounting pin -3- from the rear seat backrest frame -1-.

NOTE:

The cushion and cover are not shown in the illustration.

-- Remove the bearing sleeve -2- from the mounting pin.

scientia non olet · About LEMON Manuals