Overview - Rear Seat Backrest, Standard Seat/Sport Seat
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The 2-seat rear seat backrest is shown in the illustration.
- Center Support
- Removing and installing. Refer to CENTER BRACKET, REMOVING AND INSTALLING .
- Bolts
- 20 Nm
- Quantity: 4
- Inner Mounting Pin
- for the rear seat backrest
- Quantity: 2
- 13.5 Nm
- Removing and installing. Refer to INNER MOUNTING PIN, REMOVING AND INSTALLING .
- Rear Center Armrest
Vehicles with:
- with pass-through door
- With storage compartment
- Overview. Refer to OVERVIEW - CENTER ARMREST .
- Right 2/3 Rear Seat Backrest
Vehicles with:
- Backrest heater
- Pass-through
- Removing and installing. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- For the correct tightening specification for vehicles with side airbags, refer to OVERVIEW - REAR SIDE AIRBAG .
- Side Cushion
Vehicles with:
- Rear side airbag
- Removing and installing. Refer to SIDE CUSHION, REMOVING AND INSTALLING .
- Engage in the seat belt guide at the top first
- Right Head Restraint
- Removing and installing. Refer to REAR HEADREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT .
- Rear Center Belt Guide
- Only vehicles with 3-seater rear seat bench
- Replace the entire belt guide if damaged.
- Removing and installing. Refer to CENTER REAR SEAT BELT GUIDE, REMOVING AND INSTALLING .
- Headrest in the Center
- Only vehicles with 3-seater rear seat bench
- Removing and installing. Refer to REAR HEADREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT .
- Cover
- for the center bracket
- Removing and installing. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Bolt
- 9 Nm
- Left Head Restraint
- Removing and installing. Refer to REAR HEADREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT .
- Trim
- For locking
- Removing and installing. Refer to LOCKING MECHANISM TRIM, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Locking Mechanism
- For the rear seat backrest
- Removing and installing. Refer to REAR SEAT BACKREST LOCKING MECHANISM, REMOVING AND INSTALLING .
- Left 1/3 Rear Seat Backrest
- Removing and installing. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .
- Outer Bearing Sleeve
- Quantity: 2
- Removing and installing. Refer to OUTER BEARING SLEEVE, REMOVING AND INSTALLING .
- Press on until it engages audibly
- Securing Bracket
- For the center bracket
- Removing and installing. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .