Headrest Guide, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Upholstery, Headrest Tubes / Guides And Backrest Shell

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear headrest:

For the standard seat/sport seat, refer to REAR HEADREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT .
For the super sport seat, refer to REAR HEADREST, REMOVING AND INSTALLING, SUPER SPORT SEAT .

-- Loosen the backrest cover with backrest cushion from the rear seat backrest frame. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .

-- Move the backrest cover with the backrest cushion -1- as far up as possible until the headrest pipe -2- welded in the rear seat backrest frame -3- and the headrest guide -4- is visible.

-- Push the tab -arrow A- down and at the same time pull the headrest guide out of the rear seat backrest.

NOTE:

Ignore -arrow B-.