Front Seat Control Module Bracket, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bracket -1- & Pin -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front seat control module:

For the memory seat/steering column adjustment control module, refer to SEAT/STEERING COLUMN ADJUSTMENT CONTROL MODULE WITH MEMORY FUNCTION, REMOVING AND INSTALLING .
For the seat ventilation control module (integrated in the seat heating), refer to SEAT VENTILATION CONTROL MODULE (INTEGRATED IN SEAT HEATING), REMOVING AND INSTALLING .
Passenger Occupant Detection System Control Module -J706- - market-specific. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .

-- Press pin -2- out of the clip -arrow A- of the bracket -1- in the direction of the seat cushion using, for example, an upholstery needle.

-- Remove the pin that was pressed out from the seat pan.

-- Remove the support foot -2- from the upper frame of seat pan -1-, unclipping clip -arrow A- at the upper seat frame.

Fig 2: Bracket -2-

Courtesy of AUDI OF AMERICA, LLC

-- Detach retaining tabs -arrow B- on both sides.

-- Carefully remove bracket from the seat pan -arrow-.