Lumbar Support Adjustment Motors -V125- / -V126- / -V129- / -V130-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat. Refer to Removing .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture VAS 6136. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove backrest cover with backrest cushion:
- For the standard seat/sport seat (manual or power), refer to BACKREST COVER AND UPHOLSTERY, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
- For the super sport seat, refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, SUPER SPORT SEAT .
-- Detach electrical harness connectors -1- and -2- at the lumbar support forward/back and height adjustment motors.
WARNING:
Danger of eye injury.
- Wear protective eyewear.
-- Drill out rivet -3-.
-- Free up the electric wiring harness on the lumbar support.
-- Move the lower lumbar support -1- forward, disengage it from the backrest frame -2- -arrows- and remove it.