Front Seat, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install in reverse order of removal. Note the following:

-- Attach the connectors and remove the Airbag Lockout Adapter VAS 6282 only after installing the front seat. Refer to AIRBAG ADAPTER, CONNECTING AND DISCONNECTING .

NOTE:

Make sure the connectors are installed correctly and are secure.

-- Align the front seat -4- inside the vehicle and tighten the front bolts -1- and -2- on the seat rail hand-tight only.

Fig 1: Front Seat, Removing And Installing

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Move the front seat all the way forward/up.

-- Mount the bolts -3- and -5- on the seat rail and tighten them.

-- Move the front seat all the way to the rear and then into its highest position.

-- Tighten front bolts.

-- Airbag Lockout Adapter VAS 6282, removing and installing. Refer to AIRBAG ADAPTER, CONNECTING AND DISCONNECTING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again. .