Backrest Cover, Removing And Installing, Standard Seat/Sport Seat/Super Sport Seat: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Upper Backrest Crossmember -1-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Insert the backrest cover with the upper hooks -2- into the backrest frame -1-.

-- Tilt the backrest cover down and engage the side retaining tabs -3- and -5- and the lower hooks -4-.

-- Make sure the tabs on the side fit correctly into the backrest frame and the lower hooks are bent correctly over the backrest frame.

-- Push forcefully on backrest cover on the areas marked with the -arrows- until the tabs and hooks click into place.

Fig 2: Backrest Cover

Courtesy of AUDI OF AMERICA, LLC

-- Check if the backrest cover is correctly latched.

It must not be possible to move the backrest cover at the bottom.