Connector Station, Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Open the locking mechanisms -1- with a screwdriver.
-- Pull the connector station -2- upward -arrow A- and remove it -arrow B-. Lift the floor covering slightly, if necessary.
-- Remove the connectors from the connector station.
Connectors, connecting
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
Connecting the electrical wiring harnesses happens in reverse order, noting the following:
NOTE:
Make sure the connectors are installed correctly and are secure.