Overview - Pneumatic System, KONGSBERG MULTICONTOUR Seat Backrest
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Boot
- Bonded with backrest upholstery
- Air Cushion for the Lumbar Support
- Removing and installing. Refer to MODULE CARRIER WITH AIR CUSHIONS FOR LUMBAR SUPPORT, REMOVING AND INSTALLING .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Expanding Rivet
- Quantity: 4
- Module Carrier
- For module carrier with air cushions for lumbar support
- Removing and installing. Refer to MODULE CARRIER WITH AIR CUSHIONS FOR LUMBAR SUPPORT, REMOVING AND INSTALLING .
- Rubber Buffer
- Valve block mount
- Quantity: 4
- Valve Block 1 in Driver Seat -N475-
- Front passenger side: Valve Block 1 in Front Passenger Seat -N477-
- For lumbar support and side wall adjuster
- Removing and installing. Refer to MULTICONTOUR SEAT VALVE BLOCK, REMOVING AND INSTALLING .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Backrest Frame
- Rubber Bracket
- For blower fan
- Quantity: 4
- Driver Seat Backrest Blower Fan -V388-
- Front passenger side: Front Passenger Seat Backrest Blower Fan -V389-
- Removing and installing. Refer to BACKREST FAN, REMOVING AND INSTALLING .
- Bolt
- 6.5 Nm
- Plastic Washer
- Insert in front of the lumbar support bolting between lumbar support bracket and backrest frame