Overview - Pneumatic System, H O RBIGER MULTICONTOUR Seat Backrest
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Driver Seat Backrest Blower Fan -V388-
- Front passenger side: Front Passenger Seat Backrest Blower Fan -V389-
- Removing and installing. Refer to BACKREST FAN, REMOVING AND INSTALLING .
- Rubber Bracket
- For blower fan
- Quantity: 4
- Boot
- bonded with backrest upholstery
- Module Carrier
- Module carrier with air cushions for lumbar support
- Cannot be disassembled
- Removing and installing. Refer to MODULE CARRIER WITH AIR CUSHIONS FOR LUMBAR SUPPORT, REMOVING AND INSTALLING .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Rubber Bushing
- For multi-contour seat control module
- Quantity: 3
- Driver Multicontour Seat Control Module -J873-
- Front passenger side: Front Passenger Multicontour Seat Control Module -J872-
- The connection for the restrictor is deleted on the Original Replacement Part with an integrated check valve and the separate check value must be removed.
- Removing and installing. Refer to FRONT MULTICONTOUR SEAT CONTROL MODULE, REMOVING AND INSTALLING, H O RBIGER MULTICONTOUR SEAT .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Backrest Frame
- Bolt
- 6.5 Nm
- Plastic Washer
- Insert in front of the lumbar support bolting between lumbar support bracket and backrest frame