Rear Center Three-Point Seat Belt, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear bench seat. Refer to REAR BENCH SEAT, REMOVING AND INSTALLING .

-- Remove the right 2/3 rear seat backrest. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove the backrest cover and backrest cushion from the rear seat bench. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, REAR SEAT BACKREST .

Versions with rear seat belt tensioner igniter:

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect the connector -4-.

Fig 1: Identifying Center Rear Three-Point Seat Belt

Courtesy of AUDI OF AMERICA, LLC

-- To do this, release the connector lock -3- using a small screwdriver -1- and remove the electrical connector -2-.

Fig 2: Identifying Releasing Connector Lock

Courtesy of AUDI OF AMERICA, LLC

Continuation for all vehicles:

Fig 3: Identifying Center Rear Three-Point Seat Belt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1-.

-- Disengage the three-point seat belt -2- and remove it.

-- Guide out the seat belt -3-.