Rear Center Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hooks On Belt Roller/Belt Tensioner And Side Panel (Chassis-Body Structure)

Courtesy of AUDI OF AMERICA, LLC

-- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.

-- Insert the three-point belt with the anti-twist mechanism -1- in the mount -2- -arrow- and tighten the nut.

Versions with rear seat belt tensioner igniter:

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

NOTE:

Make sure the connectors are installed correctly and are secure.

Make sure the wires do not get caught.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

Continuation for all vehicles:

Install in reverse order of removal.