Overview - Rear Outer Three-Point Seat Belt
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolts
- Do not change the bolt position when removing and installing the belt guide. It is set by the manufacturer.
- Belt Guide
- Removing and installing. Refer to OUTER REAR SEAT BELT GUIDE, REMOVING AND INSTALLING .
- Nut
- Bolt
- 45 Nm
- If it was removed because of an accident, replace the bolt
- Automatic Belt Retractor
- Driver side: Market-specific versions with Driver Side Rear Seat Belt Tensioner Igniter -N196-
- Front passenger side: Market-specific versions with Passenger Side Rear Seat Belt Tensioner Igniter -N197-
- Removing and installing. Refer to OUTER REAR THREE-POINT SEAT BELT, REMOVING AND INSTALLING .
- Noise Insulation
- for the automatic belt retractor
- Connector
- For market version with Driver Side Rear Seat Belt Tensioner Igniter -N196-
- For market version with Passenger Side Rear Seat Belt Tensioner Igniter -N197-
- Bolt
- 45 Nm
- If it was removed because of an accident, replace the bolt
- Rear Belt Anchor
- Removing and installing. Refer to REAR OUTER BELT END FITTING, REMOVING AND INSTALLING .