LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Passenger Protection, Airbags & Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Front Seat Belt Latch, Removing And Installing >> Front Seat Belt Latch, Removing And Installing, Multicontour Seat >> Removing

Front Seat Belt Latch, Removing And Installing, Multicontour Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Deactivating the front passenger airbag on vehicles with passenger occupant detection system:

  • Replace the passenger occupant detection system seat belt latch each time the passenger belt tensioner deploys.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Remove the trim on the tunnel side. Refer to SEAT SIDE TRIM ON THE TUNNEL SIDE, REMOVING AND INSTALLING .

-- Disconnect the connector -3- and free up the wire.

Fig 1: Identifying Seat Belt Latch, Connector And Bolt
GWWA69-10524Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then remove the seat belt latch -1-.