Front Belt End Fitting, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Belt Relay Cover, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Move the front seat all the way forward/up.

Standard Seat/Sport Seat/Super Sport Seat:

-- Unclip the cover -1- on the belt relay -arrows- and fold it up.

Fig 2: Identifying Three-Point Seat Belt, Removal

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The spring -2- will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
Move the spring -2- just far enough until it is possible to unlock the tab on the spring.

-- Release the spring catches -2- by inserting a small screwdriver in the opening in the spring -arrow-.

-- Slide the belt end fitting -3- downward and disengage at the pin -1-.

Multi-contour Seat:

Fig 3: Identifying Belt Anchor, Spring Catches And Pin

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The spring -2- will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
Move the spring -2- just far enough until it is possible to unlock the tab on the spring.

-- Release the spring catches -2- by inserting a small screwdriver in the opening in the spring -arrow-.

-- Move the belt anchor -4- down and detach at the pin -3-.

-- Feed the belt anchor out up through the trim on the sill side -1-.