Front Belt End Fitting, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
CAUTION:
- The spring -2- will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
- Move the spring -2- just far enough until it is possible to unlock the tab on the spring.
-- Connect the belt anchor -3- to the bolt -1- -arrow A- and pull it up -arrow B-, until the spring catches -2- audibly lock on the bolt heat.