LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Passenger Protection, Airbags & Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Knee Airbags >> Knee Airbag With Igniter, Removing And Installing >> Driver Side Knee Airbag With Igniter, Removing And Installing >> Tighten the bolt in the following sequence: -3- and -4-

Tighten the bolt in the following sequence: -3- and -4-

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Bolts And Bracket
GWWA69-10690Courtesy of AUDI OF AMERICA, LLC
NOTE:

Make sure the connectors are installed correctly and are secure.

Make sure the wires do not get caught.

-- Replace the airbag attachments if the airbag has deployed.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again. Refer to Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals