Overview - Driver Side Airbag
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Locking bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Removing and installing. Refer to STEERING COLUMN ELECTRONIC SYSTEMS CONTROL MODULE -J527- .
- 4-spoke Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
- Wiring Set
- For Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag with Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
- 3-Spoke-Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
- Wiring Set
- For Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag with Driver Airbag Igniter -N95- and Driver Airbag Release Valve Igniter -N490-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to STEERING WHEEL, REMOVING AND INSTALLING .