Replacing A Complete Antenna Wire: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

A repair procedure has been developed for replacing antenna wires. Instead of a complete antenna wire, connecting wires of different lengths and various adapter leads are now available as replacement parts.

NOTE:

Do not repair antenna wires. Replace them using connector and adapter wires available as original replacement parts.

These original replacement parts are suitable for all antenna wires and wire cross sections that need to be replaced.

The wires are now to be used for all Audi models for all the antenna wire cross sections fitted.

All adapter leads and connecting wires are suitable for various transmission and reception signals.

The repair concept can also be used as a testing or retrofitting solution.

Special tools and workshop equipment required

-1- Adapter wire, for connection to radio; length: approximately 30 cm

Fig 1: Assembly Overview Of Antenna Wire
Courtesy of AUDI OF AMERICA, LLC
-2- Connecting wire, available in various lengths
-3- Adapter wire, for connection to antenna; length: approximately 30 cm