Replacing Tool Head

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Select the appropriate tool head based on the antenna wire test, refer to Checking the Antenna Wire .

-- Open the handle on the pliers all the way.

-- Release and remove both locking pins -arrows- from the handle.

Fig 1: Disengaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC

-- Attach the necessary tool head to the handle from the top -arrow-.

Fig 2: Identifying Insertion Of Crimping Tool Head

Courtesy of AUDI OF AMERICA, LLC

-- Insert the pins -arrows- into the handle in order to lock the tool head into place.

Fig 3: Engaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC