ESD Work Surface VAS 6613, Using
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- The electro-static discharge ESD Work Surface VAS 6613 protect electronic components from getting damaged by an electro-static charge.
- This makes is possible to perform repairs on sensitive electronic components on an open mat.
- For more information as to what work can be performed on the ESD Work Surface VAS 6613, refer to the "Electrical Equipment" in the repair information.
-- Place the electro-static discharge mat -3- from ESD Work Surface VAS 6613 on a clean, dry table.
-- Connect the Ground (GND) -2- to one of the buttons on the mat.
-- Connect the GND connector adapter -1- to the adapter connector on an outlet with contact protection or connect the alligator clip to a ground in the building or a water pipe.
-- Connect the wrist strap -4- to one of the buttons on the mat.
-- Attach the wrist strap directly to your wrist - never to your shirt sleeve or jacket sleeve.
CAUTION:
If working on especially sensitive electronic component and with the pad exposed, use only non-magnetic tools, for example, a Wrench - Driver T10072.