Overview - B-Pillar Trim Panel
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool T40280. To install, insert into the trim panel.
- Replace damaged or deformed clips
- Vent
- Equipment levels
- Removing and installing. Refer to B-PILLAR TRIM PANEL VENT, REMOVING AND INSTALLING .
- Connect electrical harness connector, first insert lower vent in the trim and press on it until it engages audibly
- Upper B-Pillar Trim Panel
- Removing and installing. Refer to UPPER B-PILLAR TRIM, REMOVING AND INSTALLING .
- Lower B-Pillar Trim Panel
- Removing and installing. Refer to LOWER B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Clip
- Quantity: 2
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool T40280. To install, insert into the trim panel.
- Replace damaged or deformed clips