Instrument Panel, Removing And Installing: Removing
-- Move the steering wheel as far down as possible.
-- Move the front seat all the way back and tilt backrests 45°.
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Follow the allocation of the airbag to the instrument panel.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the driver side airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Remove the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Remove the glove compartment:
- GLOVE COMPARTMENT, REMOVING AND INSTALLING .
- GLOVE COMPARTMENT, REMOVING AND INSTALLING, WITH KNEE AIRBAG .
-- Remove the instrument panel vent on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove front passenger side instrument panel vent. Refer to PASSENGER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove the center instrument panel vent. Refer to CENTER INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .
-- Remove the instrument cluster frame. Refer to INSTRUMENT CLUSTER FRAME, REMOVING AND INSTALLING .
-- Remove the Instrument Cluster. Refer to INSTRUMENT CLUSTER WITH INSTRUMENT CLUSTER CONTROL MODULE -J285- .
-- Remove the Front Information Display Control Head -J685-. Refer to INFOTAINMENT SYSTEM DISPLAY, REMOVING AND INSTALLING .
-- Remove the Climatronic Control Module -J255-. Refer to Climatronic Control Module -J255-, Removing And Installing .
-- Remove the Information Electronics Control Module 1 -J794-. Refer to INFORMATION ELECTRONICS CONTROL MODULE 1 -J794-, REMOVING AND INSTALLING .
-- Remove the upper instrument panel cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .
-- Remove the center mid-treble speaker in the instrument panel. Refer to CENTER SPEAKER, REMOVING AND INSTALLING .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Market-specific with knee airbag: Remove the knee airbag mount. Refer to KNEE AIRBAG BRACKET, REMOVING AND INSTALLING .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Disconnect the connectors for the front passenger airbag. Refer to FRONT PASSENGER AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Remove the Anti-Theft Immobilizer Reader Coil -D2-. Refer to ANTI-THEFT IMMOBILIZER READER COIL -D2- .
-- Vehicles with windshield projection (head up display): Remove the screws -1, 2 and 5- and remove the loose Windshield Projection Head Up Display Control Module -J898- toward the rear with the instrument panel.
-- To do this, slightly lift the control module -3- out and disconnect the connector -4-.
-- Remove bolts -1 through 4- for instrument panel on the driver side instrument panel central tube.
-- Remove bolts -1 through 4- for instrument panel on the front passenger side instrument panel central tube.
-- Remove the instrument panel bolts -1- on the center of the instrument panel central tube.
Two technicians are needed to remove the instrument panel.
-- Disengage the bottom of the instrument panel from the bracket -2- -arrows- at the same time.
-- Disconnect the connectors and free up the wiring harnesses.
-- Carefully pull the instrument panel back from the instrument panel central tube.
-- Remove the instrument panel from the vehicle interior and lay it on a soft surface.