Fuse Panel D: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Push Fuse Panel A

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Release the tab -arrow- and remove fuse panel D -2- from the relay panel -1- toward the rear.

-- Unlock the release and remove from the fuse carrier.

Fig 2: Releasing Clips And Removing Cover From Fuse Holder

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuses from the fuse panel.

-- Open the clips -arrows- and remove the fuse panel cover.

-- Pull off retaining strip -1- for harness connectors -arrow- and remove harness connectors from connector socket.

Fig 3: Pulling Off Retaining Strip For Harness Connectors And Removing Harness Connectors From Connector Socket

Courtesy of AUDI OF AMERICA, LLC

NOTE: Check the exact connector assignment in the current wiring diagram. Refer to appropriate Wiring Diagram.