Relay And Fuse Panel On Right Side -SF-: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Nut, Relay And Fuse Panel F

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the luggage compartment trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the nut -3-.

-- Cut the cable tie -4- and free up the wiring harness -5-.

-- Remove relay and fuse panel F -2- from the body -1- -arrows-.

-- Remove the mount for the 46-pin connector -T46b-. Refer to REMOVAL .

Fig 2: Identifying Push Fuse Panel A

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip in -direction of arrow- and remove the fuse panel -2- from relay and fuse panel F -1-.

-- Release the retainers -arrows- and remove the relay panel -2- from the relay/fuse panel -1- to the rear.

Fig 3: Identifying Relay Panel And Connector Station

Courtesy of AUDI OF AMERICA, LLC

-- Remove the relay and fuse panel F.

NOTE: Check the exact connector assignment in the current wiring diagram. Refer to appropriate Wiring Diagram.