Cell Phone Preparation Connector Assignment, RMC And 9ZF
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- DAB connection from Antenna Amplifier 3 -R112-, Digital Radio Antenna -R183-, QV3
- SAT connection from Roof Antenna -R216-, Satellite Antenna -R170-, only USA and QV8
- GPS connection from the Roof Antenna -R216-
- Connection block with four multi-pin connectors
- MOST bus
- 4-Pin Connector -T4z- to the External Audio Source Connection -R199-
- 4-Pin Connector -T4df- to the Front Information Display Control Head -J685-
- AM/FM/FM2 antenna connection
NOTE:
Unlisted connector terminals are not assigned.
3 - Connection block with four multi-pin connectors
- Right rear speaker (+)
- Right front speaker (+)
- Left front speaker (+)
- Left rear speaker (+)
- Right rear speaker (-)
- Right front speaker (-)
- Left front speaker (-)
- Left rear speaker (-)
- Data from Multimedia System Control Head -E380-
- RES BT Multimedia System Control Head -E380-
- Not Assigned
- Microphone input (+) from Microphone Unit in Front Roof Module -R164-, Left Front Microphone -R140-
- CVBS cable (-) for the Rearview Camera System Control Module -J772-
- DIAG signal from Telephone Baseplate -R126-
- Data to the Multimedia System Control Head -E380-
- Wake UP Multimedia System Control Head -E380-
- RES HU to the Multimedia System Control Head -E380-
- Not Assigned
- CVBS composite cable (+) for the Rearview Camera System Control Module -J772-
- Microphone input (-) for the Microphone Unit in Front Roof Module -R164-, Left Front Microphone -R140-
All pins are connected to the External Audio Source Connection -R199-.
- LF-In ground
- Right LF-In
- USB, +5 V
- USB, ground
- iPod®, ACC Power
- Detect
- Left LF-In
- LF-In ground shielding
- CVBS Cable (+)
- CVBS Cable (-)
- iPod® data
- iPod® data
9 - Subwoofer -R211- (+)
10 - Center Speaker -R208- (+)
13 - Subwoofer -R211- (-)
14 - Center Speaker -R208- (-)
17 - Terminal 31
18 - Terminal 30
7 - Ring-break Diagnostic Cable
12 - Switch-on signal to Telephone Baseplate -R126- /Cellular Telephone Amplifier -R86-
- Input
- Output
All pins are connected to the External Audio Source Connection -R199-.
- D (+)
- iPod® recognized
- D (-)
- Ground
All pins are connected to the Front Information Display Control Head -J685-.
- LVDS (-)
- LIN
- LVDS (+)
- Ground