Cellular Telephone Amplifier -R86-, REMOVING AND INSTALLING, FROM MY 2015: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

The bracket with the Digital Sound System Control Module -J525- /TV Tuner -R78- must be removed first.

-- Remove the left luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- If equipped, remove the trailer hitch lever. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES WITH TRAILER HITCH .

-- Remove the nuts -4, 6 and 7- and the screw -2- on the bracket -1-.

Fig 1: Locating Nuts -4, 6 And 7- And Screw -2- On Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brace -3-.

-- Pivot the Digital Sound System Control Module -J525- -5- with the bracket -1- into the luggage compartment.

-- If equipped, disconnect the connectors from the TV Tuner -R78-.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps VAS 6223/9 -1- onto the MOST bus connector -2-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors -2- from the Cellular Telephone Amplifier -R86- -1-.

Fig 3: Pressing Catches -Arrows- And Remove Cellular Telephone Amplifier -R86- -1-

Courtesy of AUDI OF AMERICA, LLC

-- Press the catches -arrows- and remove the Cellular Telephone Amplifier -R86- -1- from the bracket.