8RF - Advanced sound system, Bang & Olufsen, from MY 2015
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Two speakers in the left and right front doors
- One loud speaker on the left and right side of the instrument panel
- Two speakers in the center of the instrument panel
- Two speakers in the left and right rear doors
- One speaker in the left and right D-pillars
- Subwoofer - R211- in the luggage compartment recess
- Digital Sound System Control Module - J525-
There is a sound system with ANC EP1 and without ANC EP0.
- Left Front Midrange Speaker - R103- in center of left front door
- Right Front Midrange Speaker - R104- in center of right front door
- Left Rear Treble Speaker - R14- in the left rear door at top
- Right Rear Treble Speaker - R16- in the right rear door at top
- Left Effects Speaker - R209- in the left D-pillar
- Right Effects Speaker - R210- in the right D-pillar
- Left Front Treble Speaker - R20- inside the instrument panel on the left side
- Left Front Treble Speaker Motor - V344-
- Center Speaker - R208- in center of instrument panel
- Center Speaker 2 - R219- in the center of the instrument panel
- Right Front Treble Speaker - R22- in right instrument panel
- Right Front Treble Speaker Motor - V345-
- Left Rear Bass Speaker - R15- in the bottom of the left rear door
- Right Rear Bass Speaker - R17- in the bottom of the right rear door
- Left Front Bass Speaker - R21- in the bottom of the left front door
- Right Front Bass Speaker - R23- in the bottom of the right front door
- Subwoofer - R211- in the luggage compartment recess
- Microphone Unit In Front Roof Module - R164- (Interior Microphone - R74-) in the Front Interior Lamp - W1-
- ANC microphones inside the headliner
- Digital Sound System Control Module - J525- behind the left luggage compartment trim panel
- MOST bus
Notes on MOST bus
The optical Data bus " MOST bus" is used in addition to the CAN bus.
A fiber-optic cable is used as a " connecting cable". Fiber optic cables are routed inside corrugated tubes for protection.
Replace complete fiber optic cable if possible.
The front surface of the connectors must not be dirty.
If disconnecting the connectors: Attach Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9.
When installing fiber optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.
Repairing fiber optic cables. Refer to FIBER OPTIC CABLE .