Installed Calibration Tool VAS 6350 Overview

Fig 1: Identifying VAS 6350

Courtesy of AUDI OF AMERICA, LLC

1. Calibration Tool - Wheel Center Mountings VAS 6350/1
2. Calibration Tool - Wheel Center Mountings VAS 6350/1
3. Right Angle Bracket
   • Calibration Tool - Spacing Laser VAS 6350/2 mount
4. Plastic Foot
   • Three on underside of calibration platform
   • Adjustable for aligning horizontal position of calibration platform
5. Calibration Tool - Linear Laser VAS 6350/3
   • On the calibration board
   • Switching on and off. Refer to operating instructions.
6. Calibration Tool - Spacing Laser VAS 6350/2
   • On the calibration board
   • Notes on operation. Refer to operating instructions.
7. Level
   • On the calibration board
   • for checking the horizontal position
8. Left Angle Bracket
   • Calibration Tool - Spacing Laser VAS 6350/2 mount
9. Calibration Board
   • Between the mounts on the calibration board and the Calibration Tool - Wheel Center Mountings VAS 6350/1 -dimension A- 1.47 m through 1.90 m

Calibration board alignment

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see dimension -A- in the illustration Calibration Tool VAS 6350, INSTALLING AND ALIGNING .

-- Bring the Calibration Tool VAS 6350 into a horizontal position.

-- To do so, twist plastic feet under calibration device so that air bubble in level is located exactly in the center of the indicator -arrow-.

Fig 2: Identifying Bubble Level (Sight Glass) On Calibration Tool VAS 6350

Courtesy of AUDI OF AMERICA, LLC

-- Switch on the Linear Laser VAS 6350/3A -1- on the calibration board and adjust the entire Calibration Tool VAS 6350 so that the laser beam hits the center of vehicle rear above the Audi rings.

Fig 3: Switching On Line Laser VAS 6350/3

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the Audi rings are centered on the rear. Correct the laser beam accordingly.

Continue calibrating the Rearview Camera -R189-. Refer to REARVIEW CAMERA, CALIBRATING .