Calibration Requirements
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The camera lens must be clean. Cleaning
- The vehicle must be standing on a firm and level surface.
- There must be enough clearance around the vehicle (at least 2 meters).
- The parking brake must be set.
- The steering wheel must be in the 0 position and the wheels must be straight.
- All doors and the rear lid must be closed.
- No one should be in the vehicle.
- The vehicle must not be loaded (curb weight).
- Connect the battery charger.
- Ignition switched on.
Special tools and workshop equipment required
- Calibration Tool VAS 6350
- Vehicle Diagnostic Tester
The Calibration Tool VAS 6350 consists of the following parts:
- Calibration Tool - Wheel Center Mountings VAS 6350/1
- Calibration Tool - Spacing Laser VAS 6350/2
- Calibration Tool - Linear Laser VAS 6350/3