LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Communication) >> 91 Communication >> Radio >> Overview - Radio >> Overview - Radio System, MMI Navigation Plus, I8H, From My 2015

Overview - Radio System, MMI Navigation Plus, I8H, From My 2015

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

I8H - MMI Radio high, MMI Navigation plus 

Information Electronics Control Module 1 -J794- with CD player/DVD Player/SD card reader/navigation system integrated in the instrument panel

Optional 

Fig 1: Identifying MMI Navigation Plus, I8H, From My 2015
GWWA91-12305Courtesy of AUDI OF AMERICA, LLC
  1. Roof Antenna -R216-
  2. Front Information Display Control Head -J685- in center of the instrument panel
  3. Multimedia System Control Head -E380- in the center console
  4. Telephone Baseplate -R126- /External Audio Source Connection -R199- in the center console storage compartment
  5. Information Electronics Control Module 1 -J794- inside the instrument panel
  6. MOST bus
  7. Data Bus On Board Diagnostic Interface -J533- under the rear bench seat
  8. Digital Sound System Control Module -J525- behind the left luggage compartment trim panel
  9. TV Tuner -R78- behind the left luggage compartment trim panel
  10. DVD Changer -R161- in the glove compartment
  11. Microphone Unit in Front Roof Module -R164- (Left Front Microphone -R140-) in the Front Interior Lamp -W1-

The MOST bus performs the system data exchange in the MMI.

The connection to the other Data bus systems in the vehicle are provided by the Data Bus On Board Diagnostic Interface -J533-.

Fault finding is performed via "Guided Fault Finding" on the Vehicle Diagnostic Tester.

Notes on MOST bus

The optical Data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used as a "connecting cable". Fiber optic cables are routed inside corrugated tubes for protection.

Replace complete fiber optic cable if possible.

The front surface of the connectors must not be dirty.

If disconnecting the connectors: Attach Fiber-Optic Repair Set - Connector Protective Caps VAS 6223/9.

Fig 2: Fiber Optic Plier Repair Set VAS 6223
GWWW00-10202Courtesy of AUDI OF AMERICA, LLC

When installing fiber optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Repairing fiber optic cables. Refer to FIBER OPTIC CABLE .