MULTIFUNCTION Buttons, Removing And Installing, 3-Spoke Steering Wheel: Notes

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Trim Removal Wedge 3409

The multifunction buttons -2- are clipped in the trim molding -1-. The trim -1- and the multifunction buttons -2- are attached to the steering wheel. The multifunction buttons -2- have an extra retainer -3-.

Fig 1: Multifunction Buttons Are Clipped To Decorative Trim

Courtesy of AUDI OF AMERICA, LLC

While removing, first make sure the trim -1- can be loosened by hand (approximately 5 mm). Then, using the Trim Removal Wedge 3409, open the retainers -3- on the multifunction buttons -2- and remove the trim -1- together with the multifunction buttons -2-.

Fig 2: Identifying Trim Retainers

Courtesy of AUDI OF AMERICA, LLC

Trim Molding

Arrows - tabs

Fig 3: Identifying Multifunction Button Retainers

Courtesy of AUDI OF AMERICA, LLC

Multi-function button
Catch