Display Front And Rear Cover, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Bring the display into service position. Refer to DISPLAY SERVICE POSITION .

-- Remove the display with the kinematics:

6.5 inch. Refer to 6.5 INCH DISPLAY WITH KINEMATICS, REMOVING AND INSTALLING .
8 inch. Refer to 8 INCH DISPLAY WITH KINEMATICS, REMOVING AND INSTALLING .

First the Front Information Display Control Head -J685- is disconnected from the kinematics.

-- Follow the guidelines for ESD (electro static discharge), refer to DISPLAY FRONT AND REAR COVER, REMOVING AND INSTALLING .

-- Remove the mounting pin -3- and the bearing sleeve -4- from the display support -1-.

Fig 1: Removing Mounting Pin -3- And Bearing Sleeve -4- From Display Support -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the display support -1- from the kinematics -2-.

-- Unclip the rear cover -2- from the display support with display -1-.

Fig 2: Unclipping Rear Cover -2- From Display Support With Display -1-

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the front cover -1- from the display support with display -2-.

Fig 3: Unclipping Front Cover -1- From Display Support With Display -2-

Courtesy of AUDI OF AMERICA, LLC