6.5 Inch Display With Kinematics, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Install in reverse order of removal. Note the following:

-- Make sure that the wiring guide of the Front Information Display Control Head -J685- to the wiring harness and Information Electronics Control Module 1 -J794- is followed exactly -arrows-, otherwise the Front Information Display Control Head -J685- will not extend out.

Fig 1: Identifying Connectors And Clips

Courtesy of AUDI OF AMERICA, LLC

-- First install the clip in the center -2-, then connect the display connector -1- and -3- and then install the rear clip -4- and finally connect the engine connector -5-.

-- Slide the Front Information Display Control Head -J685- into the instrument panel and tighten the screws -2- hand-tight.

Fig 2: Identifying Screws And Front Information Display Control Head -J685- -1-

Courtesy of AUDI OF AMERICA, LLC

After installing the center vents, align everything and tighten the screws.