Bumper Antennas, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

LTE Antenna 1 -R297- on the rear bumper on the right side.

-- Release and disconnect the connector -5- for the LTE Antenna 1 -R297- -1-.

Fig 1: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4- for the LTE Antenna 1 -R297- -1-.

-- Remove the LTE Antenna 1 -R297- -1- from the bracket -2-.

-- Remove the nuts -3- for the bracket -2-

-- Remove the bracket -2- from the vehicle body.

GSM Antenna -R205- on the rear bumper on the left side.

-- Release and disconnect the connector -5- for the GSM Antenna -R205- -1-.

Fig 2: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4- for the GSM Antenna -R205- -1-.

-- Remove the GSM Antenna -R205- -1- from the bracket -2-.

-- Remove the nuts -3- for the bracket -2-

-- Remove the bracket -2- from the vehicle body.