Transmission Fluid Auxiliary Hydraulic Pump, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
- Pay attention to the general repair information. Refer to the appropriate General Technical Data article .
- Pay attention to the guidelines for clean working conditions. Refer to the appropriate General Technical Data article .
-- Move the selector lever into "P".
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to the appropriate Service Information .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Carefully disconnect the connector -B- for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A-.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- -A- from the transmission housing.
- The Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- fits tightly into the transmission housing because of the O-ring -D-.