Transmission Fluid Auxiliary Hydraulic Pump Wiring Harness, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting Connector From Transmission Housing

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

If the old wiring harness -1- is to be reinstalled, then replace the O-rings on the connector -4-.
Connector installation position -4- : insert with the flat surface toward the housing rib -5- as shown.

-- Press the lock washer -A- onto the connector -B- for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- wiring harness opposite the direction of -arrow- and secure it.

Fig 2: Identifying Wiring Harness Connector -B- And Lock Washer -A-

Courtesy of AUDI

-- Press the connector terminals -2 and 3- into the holes on the transmission housing, as marked during removal.

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .

-- Install the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .

-- Install the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .

-- Install the transmission fluid pan. Refer to the appropriate Service Information .

-- Fill the ATF. Refer to the appropriate Service Information .