Overview - MECHATRONIC, 0D7 And 0DY
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
Coat O-rings and seals with ATF. Other types of lubrication leads to faults in the transmission control module hydraulics.
- Transmission Fluid Pan
- With integrated ATF filter
- Removing and Installing. Refer to the appropriate Service Information .
- Seal
- Replace after removing
- O-Ring
- Replace after removing
- Bolt
- Tightening specification and sequence. Refer to MECHATRONIC TIGHTENING SPECIFICATIONS .
- Replace after removing
- Bolt
- 10 Nm
- Wiring Harness
- For Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .
- O-Rings
- Replace after removing
- Lock Washer
- O-Ring
- Replace after removing
- Bolt
- 5.5 Nm
- Connector Housing
- Replace after removing
- O-Rings
- Replace after removing
- ATF Pipe
- Replace after removing
- Seals
- Replace together with the ATF line -item 13- 13.
- O-Ring
- Replace after removing
- Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-
- Removing and Installing. Refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Replace after removing
- Quantity: 3, M6x28
- Mechatronic
- Removing and Installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- O-Ring
- Replace after removing
- ATF Drain Plug
- Tighten all the way
Transmission Fluid Pan - Tightening Specification and Sequence (12 bolts)
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 12- | Install the bolts by hand until the bolt heads touch |
| 2. | -1 to 12- | 4 Nm |
| 3. | -1 to 12- | 10 Nm |