Hydraulic Pulse Memory With Accumulator Solenoid -N485-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Move the transmission into the "P" position.
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to the appropriate Service Information .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Disconnect the connector -B- for the hydraulic pulse memory -A- carefully.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the hydraulic pulse memory -A-.