Hydraulic Pulse Memory With Accumulator Solenoid -N485-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the O-ring and bolts for the hydraulic pulse memory.
-- Install the hydraulic pulse memory -A- with a new O-ring -D-.
-- Tighten the bolt in the following sequence: -1 to 3-.
- -1- : M6x59
- -2 and 3- : M6x20
-- Connect the connector -B- and engage them.
-- Route the wire -C- according to the illustration and secure it -arrows-.
-- Install the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
-- Install the transmission fluid pan. Refer to the appropriate Service Information .
-- Fill the ATF. Refer to the appropriate Service Information .