Driveshaft, Removing From Rear Final Drive And Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Counterhold Tool Touareg V10T10172 with Adapters T10172/5
Adapter T10172/5 (M8 bolts)
Adapter T10172/6 (M10 bolts)
High temperature grease G 000 633

See notes, refer to .
Working on the driveshaft should only be performed with the vehicle on a two-column shop hoist.

Remove the driveshaft from the rear final drive.

-- Separate the exhaust system at the clamping sleeves -1 and 2-.

Fig 1: Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

Do not bend the decoupling element in the front exhaust pipe more than 10°, otherwise it will get damaged. Tie up the front exhaust pipes to the body.

A second technician will be needed to help remove the rear section of the exhaust system.

-- Remove rear portion of exhaust system. Refer to [For engine(s) CPNB] Exhaust System, Emission Controls .

-- Check whether there is a marking (color marking) on driveshaft and at flange/driveshaft at rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a new color marking.

Die marking on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.

Rear Final Drive 0BF

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 3: Counter Hold Using Counterhold Tool Touareg V10 T10172 And Adapters T10172/5

Courtesy of AUDI OF AMERICA, LLC

-- Counterhold using the T10172 and T10172/5.

-- Remove the driveshaft from the rear final drive and lay it on the subframe.

Rear Final Drive 0BE

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 4: Driveshaft Center Bearing Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Counter hold using the T10172 and T10172/6.

-- Remove the driveshaft from the rear final drive and lay it on the subframe.