Attach the driveshaft to the rear final drive.
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Be sure to note the following:
- Remove any old or dried-up high temperature grease from the CV joint and the driveshaft flange. Fill with the exact same amount of high temperature grease G 000 633.
- Threaded holes in the flange shaft at rear final drive must be cleaned of locking compound residue. Use a thread cutter to clean the holes. Otherwise the bolts could break off when being installed.
- After disconnecting driveshaft from rear final drive, an additional balance washer (thick washer) that may be located between shim and a bolt may not be reinstalled.
- Always replace (self-locking) securing bolts for driveshaft.
- Check the driveshaft seal on the rear final drive for damage (bent or the rubber has started to peel) Replace a damaged gasket.
-- Position the driveshaft on the rear final drive paying attention to the installed position:
- Die markings on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.
- Maximum difference between the markings: 30°.
-- Install and tighten the driveshaft bolts -1-. Follow the tightening sequence, refer to Figure.
-- Install rear section of the exhaust system. Refer to [For engine(s) CPNB] Exhaust System, Emission Controls .