All Wheel Drive (AWD): Pump: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a hoist.

Turn off the ignition.

-- Place the drip tray under the rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive (AWD) pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the 4 AWD pump bolts on the hydraulic control unit using the T10058.

-- Carefully remove the AWD pump -2- while paying attention to the adapter -item 4- HYDRAULIC CONTROL UNIT => List Item:Adapter in the hydraulic pump.

NOTE:

The adapter could fall out when removing the AWD pump.

Insert the adapter into the recesses in the hydraulic pump before installing the AWD pump.